The continuous process of urbanization results in demands on research and development for ecological and sustainable city development. Because of this, the current systems for wastewater treatment may have to be improved. In order to evaluate new technologies for municipal wastewater treatment, a development project has been initiated for the new district Hammarby Sjöstad in Stockholm. The project is lead by the company Stockholm Water. High environmental standards have been put up for the district, as it must be twice as good as an ordinary new district.

At Degermyran landfill, situated in the municipal Skellefteå, a leachate treatment system was installed in 2005. One of the aims of this study was to investigate how well the treatment system works by using data from chemical measurements made on the leachate before and after treatment. Further this study had the purpose of investigating how the predicted climate changes of the 21st century will affect the amount of leachate generated at Degermyran by using a modified version of Thornthwaites water balance model. The treatment system has the ability of reducing manganese by 90 %, nitrogen by 73 % och TOC by 79 %. By the turn of this century the amount of precipitation that percolates the waste at Degermyran will be between 254 and 298 mm, depending on the amount of greenhouse gases that will be released in the future to come.

The management of water resources and waste water varies between the countries of the EU. For many years, a large part of the water in Europe has been contaminated by, among other things, insufficiently treated waste water and emissions from agriculture. The EU Water Framework Directive 2000/60/EC and the Urban Waste Water Directive 91/271/EEC are intended to harmonize fresh-water management and waste water management within the whole EU, aiming at safeguarding drinking water of good quality and a high quality of all water within the EU today and in the future. There are however some problems concerning the waste-water directive. One problem is the huge investment needed in Slovakia to fulfil the demands of the waste-water directive for waste-water management in larger communities (with more than 2000 inhabitants).

In Sweden, the eutrophication of lakes, water courses and the coastal areas is considered the major threat to aquatic ecosystems and therefore actions taken to reduce the nutrient load to aquatic system including the Baltic Sea has high priority. There are many different sources of phosphorous and nitrogen and domestic wastewater is one contributing factor to the high load. Especially waste water from households that is not connected to municipal sewage treatment or a local small scale plant with appropriate nutrient removal efficiency is considered a problem. These types of households are quite common in rural areas in Sweden and in areas where summer houses has been converted to permanent living. Swedish legislation now permit the municipalities to decide in which areas within the municipality higher demands of the local small scale treatment facility should be met by the households (i.e.

Water logistics has long been a problem in order to effectively carry out stump treatment in both thinning and final felling. It is important that the stump treatment? equipment is configured as well as a sufficient amount of water is carried out on the harvester to get a cost? effective treatment. The flow control of the equipment has improved and water can be dispensed more efficient, but still the amount of water on the machine is a crucial factor in the total cost estimate. The knowledge of the tools available to bring water as well as the internal logistics of loading and transport to the felling site is deficient. Increased focus on "smart" solutions to manage water cost is of great importance in order to combat Hetrobasidion spp in both thinning and final felling. The purpose of the study is to describe and summarize different solutions of water logistics at stump treatment in final felling.

Stump treatment today requires large quantities of clean water mixed with the protective product Rotstop, to fully cover the stump surface. In order to reduce the water consumption without reducing the coverage of the stump surface, the pressure in the stump treatment device can be increased. Therefore, the Phlebiopsis gigantea (Fr.) Jül. suspension used as a biological control agent to prevent Heterobasidion annosum (Fr.) Bref. infection was pressure-tested.

Water is an important food and an important natural resource. In order to protect these are the Environmental Code and the EU directive given to water protection and related water protection regulations will be established for all water sources until 2010. Those who will prepare a water protection and related water protection regulations is the municipality or person responsible for water supply. The person then decides and declares the area as water protection and related water protection regulations are municipal or provincial government. The idea of creating a water protection is to protect the water supply and the body of water against pollution caused by point sources, diffuse sources and accidents combined.

This pilot study examined whether treatment with Vortex Process Technology (VPT) of the irrigation water used on tomato (Solanum lycopersicum) plants had any effect on plant growth. In a block experiment, with two blocks comprising 12 vases containing 1 L water and two tomato plantlets, treatment in which, nutrient solution was based on Vortex-treated water was compared with an control using untreated water. All vases were kept in a static aerated culture system in a daylight chamber for four weeks. The results showed that the effect of the two blocks exceeded the effect of vortex treatment in terms of leaf area and weight of fresh and dry matter. Plant height, stem width and internodal length were significantly different in tomato plants grown in Vortex-processed water compared with the untreated control.

The objective of this report was to analyse and compare vulnerability and preparation in Swedish municipal drinking water production, in case the commonly used water sources were inoperative. Methods used were a questionnaire and a less extensive study of regulations for water protection areas. The questionnaire was answered by 41 Swedish municipalities. A handful of them were companies co-owned by a few municipalities. Only one out of four municipalities had source protection areas to all their water sources and for many sources the protection was not satisfactory.

Treatment wetlands been showed efficient for reducing pollutant in waste water. In Lajeado ? RS, Brazil the landfill has poor leachate water treatment. It is necessary to supplement the treatment plant because they need to reduce BOD, COD and nitrate of the water going to recipient. A subsurface flow wetland (SSF) can be a good choice.  In order to be able to design an efficient SSF it is important to understand how the grain sizes of a substrate affect the reducing of pollutants in waste water.

Amongst the published literature researching wet cleaning of paper there is a limited amount of studies conducted researching the method simmering water treatment. There are even less studies conducted on how simmering water affects the paper being treated when used as a cleaning method. Despite the limited research, there are literary reviews describing the method and suggesting it as an alternative for conservation of paper with iron-gall ink. The following study will therefore be examining, the somewhat unusual method, simmering water treatment, and comparing it to one of the more common wet cleaning methods: immersion washing. This is done to compare how the different temperatures of the water affect the paper. The types of paper used in this study consists of three dyed and four undyed papers. All of the papers are new, apart from one sample originating from 1847.

In the next few years the pollutants loading at the Slottshagen wastewater treatment plant in Norrköping is going to increase due to the reason that one of the waste water treatment plant in the district will be shut down.A survey of how these different pollutants are divided in the treatment process is therefore necessary for mapping out both the loading and treatment efficiency.This can be achieved by studying mass balances.Mass balances were carried out for the water treatment process for the mechanical/chemical,biological and the chemical stage.The mass balance studies show that the treatment efficiency was very good. However in order for the mass balances to be quite consistent and to ensure complete coverage of results and conclusions i.e. more reliable results, sludge samples should be collected and taken at different times per day and the influent rate should be investigated.In this work mass balance has been set up in order to illustrate and identify the factors that should be considered and taken care of for further estimation using mass balances in the future. Furthermore this survey results in a calculating model for the mass balances at thisplant.This calculating model is used as a tool to facilitate future calculations for mass balances for the water treatment process at Slottshagens wastewater treatment plant.Moreover it provides a basis for carrying out further estimation of the treatment process in the near future.In this project the importance of some operating parameters was also taken in consideration.This calculating model can be modified so that calculations of such operating parameters i.e. sludge loading and sludge age can be easily performed.Such information can be used further to evaluate different operation alternative in order to ensure an optimal use of the treatment process with in the plant..

In some coastal areas in Sweden water shortage sometimes appears because the withdrawal of groundwater is greater than the groundwater recharge. It creates a situation where the available groundwater is insufficient to support residents and businesses with drinking water. The high withdrawal of groundwater also creates a risk for saltwater intrusion to drinking water wells. The problem most commonly occurs during the summer when the groundwater recharge is low, but the population is high, due to tourism and summer residents.The purpose of this study was to investigate how local water supply in areas affected by water shortage can be solved as sustainable as possible. The work was divided into three parts where the first part comprised of a literature review on water systems in which four different options were investigated: artificial groundwater recharge, rainwater harvesting, desalination and water reuse.

ABB I-R Waterjet Systems combines the robotics and motion expertise of ABB Flexible Automation with high-pressure intensifier/pumping technology from Ingersoll-Rand to provide and continue to develop innovative waterjet cutting systems for global markets. The purpose of this assignment is to develop a process water purifier. The purifier should be applicable as an option to ABB I-R?s production cell Cutting-Box. At first hand the process water should be purified well enough to let out in the municipal sewage system, but the ultimate solution is purifying the process water to the range that recycling is possible.

Because of the increasing trends in energy consumption and increased environmental awareness, greater focus has been placed on improvement and development of renewable energy sources. An already proven and accepted method is biogas production from anaerobic digestion at municipal wastewater treatment plants.In the waste water treatment process solid material and dissolved pollutants are separated from the water, forming a sludge. The sludge is separated from the process and stabilized during anaerobic digestion or aerobic aeration. Most often, mesophilic anaerobic digestion is used. Because of degradation by microorganisms, biogas with a high content of methane is formed during the digestion.